Your question: Will a 302 bolt fit a 2 3 transmission?

What transmission goes with a Ford 302?

For years, the Ford C-4 automatic was a reliable three-speed automatic transmission for many Ford products, and is fine for most 289, 302 or 351 engines that have received modest modifications.

Will a C6 transmission bolt a 302?

Premium Member. The C6 will physically bolt onto either the 289 or 302 but I don’t think it will fit the 66 tunnel without some modification to the tunnel. It should fit the 68 tunnel fine, since a big block with a C6 was available that year.

Is a 302 bellhousing the same as a 351?

The bellhousing bolt pattern is the same as a 302, so all trannies that bolt to a 302 will bolt to a 351.

Will a T5 transmission fit a 302?

This Deluxe T5 Transmission Conversion Kit will fit your 1969 Mustang with a 289, 302 or 351 Engine. To accomplish the conversion, the kit utilizes the late model bellhousing and cable linkage setup.

Will a 4R70W fit a 302?

The 4R70W utilizes the Engines Throttle Postion sensor to more precisely and electronically control line pressure. It can even be used on a carburated 302 if a aftermarket sesnor is installed.

IMPORTANT:  Are Transmission Lines DC?

Will a 351 transmission fit a 302?

* All the parts from the 302 with the exception of the distributor and intake manifold will fit a 351w, but some of them may be undersized. * Motor mounts will be the same, exhaust will sit a little bit higher due to the extended deck height on the 351.

What motor will bolt to a C6 transmission?

The 351m, 400, 429, 460 all bolt up to the C6 transmission without any adapters.

How do you tell a C4 from a C6 transmission?

On the C4, there will be 11 bolts while on a C6, there will be 17. Ascertain where the drain plug is situated at the transmission pan. If the plug is at the side of the transmission’s pan, it is the C6 but on the bottom means it’s a C4.

How many speeds is a C6 transmission?

Produced from 1966–1996, the Ford C6 transmission is a heavy duty 3-speed automatic gearbox that saw use in some of the Blue Oval’s most popular models.

Are all T5 transmissions the same?

While there are numerous configurations of the T5, because of the large quantities of T5’s produced, many parts are interchangeable. There are now over 200 different T5 transmission assembly part numbers and almost as many ways to customize them to fit just about anything whether passenger car or light duty truck.

Will a T5 transmission fit a 289?

Hi Dave, Your T-5 & bellhousing will fit right onto your 67 289. You’ll need a 28oz 157 tooth flywheel. I have everything you’ll need in stock, even in aluminum.

IMPORTANT:  How many blower motors are in a car?

Is a T5 transmission an automatic?

Today, for a number of reasons, installing an automatic transmission in a rod or custom is no longer the automatic decision (no pun intended) it was in the last few decades. … The T5 is the only American-made standard transmission to span almost 20 years of production (GM’s Muncie four-speed previously held that honor).