Will a blower motor work without the resistor?
If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.
Can you drive a vehicle without a blower motor?
Your car’s blower motor is not only necessary for the operation of your air conditioner. Without a functioning blower motor your engine runs the risk of overheating. … Start car and see if blower motor works.
What happens when a blower motor resistor goes bad?
The most common symptom of a failed blower motor resistor is when the heater fan only runs at the highest speed setting (4 or 5) and doesn’t work at low speeds. In some cars, a failed blower motor resistor can cause a heater fan to stop working completely.
How do I know if my blower motor resistor is bad?
Symptoms of a bad heater blower motor resistor
- Fan does not work at all, so no air comes out of the vents.
- Fan only works on some speeds and not others.
- Fan only works on the highest speed.
- Fan runs all the time and can’t be controlled with the fan switch.
- You see smoke coming out of the vents.
How do you know if you have a bad blower motor?
You might also hear ongoing whirring noises, or noises that change or get louder if you increase the fan speed. These are all signs of problems with the blower motor. In some cases, you may even notice smoke or smells of burning while driving, in which case you should pull over immediately.
What is a blower motor resistor for?
The blower motor resistor is responsible for controlling the blower motor speed. … Each fan speed selection is connected to one or more of the resistors in the blower resistor assembly. The change in resistance controls the current through the blower motor, which in turn limits the speed that the blower motor spins at.
How much does it cost to replace a motor blower?
Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.
How important is a heater blower motor?
The blower motor is an important part of your vehicle’s air conditioning and heating system, as it allows you to control the temperature inside the cabin.
Why does my blower motor resistor keeps melting?
Trent, one of the biggest reasons for blower motor resistors to have shorten life is actually because of faulty blower motor drawing too many amps, some times melting wires/plugs, heating up resistors shortening their life.
How much does it cost to replace a blower resistor?
The average cost to replace the blower motor resistor at a repair shop is between $44 and $55 in parts and $70 in labor costs, for a total cost of around $114 to $125.
Why does my blower motor only work on high?
Most car manufacturers use a series of resistors to make the heater blower motor run at different speeds. And when one or more of these resistors burn out, you’re usually left with only one heater blower motor speed—high. The resistor module is easy and inexpensive to replace.
How do I test a blower motor resistor?
Place one lead of the Ohmmeter on terminal 1 of the resistor. Place the other lead on terminal 2 and check against specifications. If this circuit is open, showing infinity on the Ohmmeter, the blower resistor must be replaced. Move the lead from terminal 2 to terminal 3 and check this reading against specifications.
How much is a motor blower resistor?
How much are new resistors? Replacement blower motor resistors usually cost somewhere between $25-120, depending on the type of resistor and the model of your vehicle.
What can cause a blower motor to stop working?
In a situation where the motor doesn’t work on any speed, the most likely causes are: a blown power supply fuse, a bad motor ground connection, bad motor speed control module or a failed motor. On all systems, a failed blower motor is least likely. … Start by checking the blower fuse and HVAC controller fuse.